Violent Bob Long Marq Trigger

Violent Series of triggers for the Bob Long MARQ markers. This trigger is made of Acetron so it is very light weight, very responsive and has that "snappy" feel. This trigger uses dual specialized flanged bearings with extended inner rings. The bearing flanges ensure that no matter how many cycles, or how hard the use, the trigger body will NEVER "walk" off of the bearing to bind on the sides of the grip frame. The extended inner rings work to position the trigger body precisely within the frame so that at no point in its travel is the side of the trigger permitted to rub the frame. We include a custom made pin that locks the extended inner rings to the side of the frame. What this means is that the trigger actually uses the bearings to pivot and also virtually eliminates all side to side play. The only side to side play you will feel is the slight play in the bearings. The front face of the trigger has a nice radius that runs down the full legnth of the trigger. The radius on the front gives you a nice feel and contact point with your fingers, not a flat front and corner edge like other triggers on the market. The trigger is only available in Black because of the nature of the material.

We have added a pre travel adjustment which allows you more adjustability. We also include an extra post travel screw. This extra screw will allow you to change the rake of your trigger to a more forward position and still achieve the correct post travel stop for your trigger activation setup. (see pic below for example)

Here is what you get:

- Complete installation instructions

- Made of Acetron

- Percision dual ball bearing pivot with extended inner rings

- Custom pivot pin

- Pre travel, post travel and micro switch adjustment points

- Extra post travel screw to adjust the trigger for a longer rake (see pic below for example)

- .050 and 5/32 allen wrenchs for adjustment and installation