DOP A-5 Blade Trigger

Shoot faster with two fingers. This kit drops right into the A5 grip frame.

No cutting required. Made of 30% glass filled composite material.

Performance Enhancements:

Rate of fire.

Less finger fatigue.

Better sweet spot with GTA Response Trigger

Compatablity:

Tippmann A5 only

Tippmann A5 GTA E-Grip (Remove slide clip and spring from trigger)

Tippmann A5 GTA Response Trigger

Tippmann A5 GTA Comp-Air LP

Dead On A5 Pro-Seal

Dead On A5 Rear Velocity Adjuster

Installation instructions: Diffficulty level <1 easy -5 difficult> 3

Tools required: Small phillips screw driver, 1/8 allen wrench

Never work on a marker with tank installed.

1. Remove your tank.

2. Remove push pins holding the grip.

3. Remove (3) phillips head screws and #10 low head screw.

4. Remove saftey pin.

5. Remove trigger assembly with trigger plates.

6. Remove laft trigger plate.

7. Replace the stock trigger Dead On double trigger.If using an E-GRIP remove the pin inside the trigger slide, trigger slide, and spring for the unit to work properly with the E-GRIP.

8. Replace the leftside triger plate. Install safety pin.

9. Replace stock trigger guard with your Dead On double trigger guard.

10. Replace left side grip frame and install (3) phillips head screws and #10 low head screw.

11. Re-install grip frame and push pins.

12. Cock and test your Dead On Double Trigger.

13. Re-install tank
Eye protection designed for paintball use must be worn at all times when handling this marker by the user and any person in range.